IR Flame sensor 2 pin (With Arduino)
IR Flame sensor 2 pin (With Arduino) Introduction The IR Flame sensor is often overlooked and is rarely acknowledged, but it plays a big role in keeping people and equipment safe. It is used a lot in nuclear facilities, gas pipelines, and oil pipelines. It is always good to know how they work and operate. Just like the Photoresistor , it is very easy to wire up and code them. A quick history of flame sensor The Flame sensor was invented by Francis Robbins Upton back in 1890. It sets off an alarm when heat is detected in a room. The Flame sensor we are talking about in this article uses the infrared light found in gasses that are released from fires. For over 130 years fire protection has played a big role in the safety industry by allowing us to automatically detect a fire and, prevent it from spreading further. What you will need 1x Arduino UNO 1x Breadboard 3x Jumper wires 1x 10K ohm resistor 1x IR Flame sensor Steps 1. Wire up the circuit according to the diagram...
